WAGNER Paint Crew Owner's Manual download pdf (Page 4)

English

Components and Assembly

ON/OFF Switch:

The ON/OFF switch turns the power to the sprayer on and

off (O=OFF, l=ON).

Spray Gun:

The spray gun controls the delivery of the fluid being

pumped.

Spray Hose:

The spray hose connects the gun to the pump.

Return Tube:

Fluid is sent back out through the return tube to the original

container when PRIME/SPRAY knob is in PRIME position.

PRIME/SPRAY Knob:

The PRIME/SPRAY knob directs fluid to the spray hose

when set to SPRAY or the return tube when set to PRIME.

The PRIME/ SPRAY knob is also used to relieve pressure

built up in the spray hose (see Pressure Relief Procedure,

page 5).

Weight..............................25 lbs.

Capacity ..........................2 gallon hopper

Power source..................3/8 Hp universal motor

Power requirement.........15 amp minimum circuit on 120 VAC,

60 Hz current.

Generator ........................8000 Watt.

Max. spraying pressure ...2800 PSI

Safety features: Spray gun trigger lock and pressure diffuser;

built-in tip safety guard; PRIME/SPRAY knob for safe pressure

release.

Conforms to UL STD 1450. Certified to CAN/CSA C

22.2 NO 68-92.

Capability:

Sprays a variety of paints, latex, primers, stains,

preservatives and other nonabrasive materials, including

pesticides and liquid fertilizers.

Do not use materials with

flash points below 70°F (21°C).

Specifications Controls and Functions

This pump should not be used with textured materials, block filler, lacquers, industrial enamels, or asphalt sealer or

materials containing HHC. See coating supplier if flash point is not listed on the container.

1. Place the handle over the unit

frame. Insert the bolts and tighten

the wing nuts over the lock washers.

3. Thread the other end of the hose to the

spray gun. Hold the gun with one

adjustable wrench, and tighten the hose

nut with the other.

Components / Assembly

Rear handle

Hopper lid

ON/OFF switch

Inlet valve tool

PRIME/SPRAY knob

Handle

Return tube

Outlet

valve

Tip storage

Inlet filter

(inside of

hopper)

Hopper

Spray guard

Spray gun

Spray hose

Spray tip

2. Thread one end of the high pressure

spray hose to the outlet valve.

Tighten with an adjustable wrench.

Do not plug in the unit until setup is complete.

1 2 3 4 5 ... 20

Comments to this Manuals

No comments

WAGNER Paint Crew Owner's Manual Page 4

Comments to this Manuals

Related products and manuals for Paint Sprayer WAGNER Paint Crew