WAGNER 9190 Owner's Manual

EnglishOwner’s manual: Read this manual for complete instructions1-800-880-0993Wagner Technical Service1770 Fernbrook Lane, Plymouth, MN 55447http://

10EnglishGood spray patternPaint tailing pattern(pressure too low,clogged tip)1. Switch the pump ON (l).Turn the PRIME/SPRAY knob toSPRAY. Turn the p

11EnglishSpraying Troubleshooting - Unclogging the Spray TipNOTE - Do not use a needle or other sharp pointed instrument to clean the tip. The hard t

12EnglishSpraying Troubleshooting - Cleaning the Spray Gun FilterThe filter must be cleaned every time you use your sprayer. When using thicker spray

13EnglishCall 1-800-880-0993 if you have any problems or questions regarding the cleaning of your sprayer.1. Lock the gun and remove the spray tip ass

14English5. Unclip the return tube from the suction tube and place itinto the waste container. Turn the PRIME/SPRAY knob toPRIME.8. While pulling the

15English1. Lock the gun and remove spray tip assembly. Submergesuction set into a bucket with appropriate cleaningsolution.2. Place a waste containe

16English1. Lock the gun and turn the pump OFF (O).3. When suction set is clean, thread the suction tube backinto the inlet valve, and replace the ret

17English1. Make sure the pump is switched OFF (O). Make sure thePRIME/SPRAY knob is turned to PRIME. Unplug thesprayer.2. Remove spray gun from the

18EnglishFollow these steps when using latex materials only. If using materials that are oil-based, follow the Cleanup - Oil-basedmaterials and Long-

19English1. Fill a cup or other container with separating oil(approximately 2 ounces) supplied with the unit andsubmerge the inlet valve into the oil.

2EnglishImportant Safety Information • Read all safety information beforeoperating the equipment. Save these instructionsIndicates a hazardous situat

20English(a)1. Remove the suction set. 2. Unscrew the inlet valve assembly (a) from the sprayer.Visually inspect the inside and outside of the inle

21EnglishFluid Section Seal Replacement InstructionsAlways wear protective eye wear while servicing the pump. Be sure to follow the Pressure Relief P

22EnglishTroubleshooting / MaintenanceProblemA. The sprayer does not start.B. The sprayer starts but doesnot draw in paint when thePRIME/SPRAY knob is

67EnglishFrançaisEspañolParts List • Liste de pièces • Lista de piezasModel GX-05 spray gunItem Part # Description Quantity1 0501011 Guard Assembly ..

68English Français EspañolParts List • Liste de pièces • Lista de piezasModel GX-08 spray gunItem Part # Description Quantity1 0501517 Tip, 517...

69EnglishFrançaisEspañolParts List • Liste de pièces • Lista de piezasSuction setItem Part # Description Quantity1 0516197 Suction set (9140S) ...

70English Français EspañolParts List • Liste de pièces • Lista de piezas1635278910114Item Part #Description Quantity1 0512336 Stand assembly (9140S)

71EnglishFrançaisEspañolAccessories • Accessoires • AccesoriosPart # Description0516913 Separating Oil0154830 Hose, Whip End, 5’ x 3/16”0270192 Hose,

72English Français EspañolWarranty • Garantié • GarantiaGARANTIE LIMITÉEMATÉRIEL DE PULVÉRISATION DE PEINTURE SANS AIRCe produit, fabriqué par Wagner

3EnglishHAZARD: GENERALCan cause severe injury or property damage.PREVENTION:• Read all instructions and safety precautions before operatingequipment

4EnglishComponents and DescriptionON/OFF Switch. . . . . . . . . . . The ON/OFF switch turns the power to the sprayer on and off (O=OFF, l=ON).Suction

5EnglishComponents and Description915091709190GX-07GX-07GX-08415517517517519521Yellow (fine)9140S, 9146 GX-05 415 415 Yellow (fine)White (medium)White

6EnglishAssembly•Two adjustable wrenches• 3/16” Allen wrenchTools needed for assembly:If you have one of the cart models (9146, 9150, 9170 or 9190), f

7EnglishBefore you begin -This section contains instructions thatwill be repeated throughout this manual.Locking the Spray Gun:Model GX-05 and GX-07 S

8EnglishPurging and Priming the SprayerAll new units are performance-tested at the factory and are shipped with test fluid in the fluid section to pre

OSPRAYPRIME9EnglishPurging and Priming the Spray Hose1. Unlock the spray gun and turn the PRIME/SPRAY knob toPRIME. 2.PULL the trigger and aim the sp