WAGNER CONTROL SPRAY Owner's Manual download pdf (Page 14)

English

Reassembly

To Reassemble:

1. Install the nozzle seal* with the groove (a) (slot) facing

toward the nozzle (away from the front end assembly).

Insert the nozzle. Make sure to align the groove (b) and

notch (c) and align the nozzle opening with the needle.

2. Put the air screen (d) in the air cap (e). Put both on the

nozzle (f) and secure with the connecting nut (g).

Note: This step is easier if the iSpray nozzle is facing up.

3. Snap the adjustment ring (h) into the connecting nut,

enabling the adjustment lever (i) on the peg (j) to be

positioned in the air cap.

Note: Make sure that the two recesses on the adjustment

ring are engaged in the air cap tabs.

Note: Make sure the air valve tube is free of paint. If not,

clean the air valve tube by following the instructions on

the next page. If clean, make sure it is attached securely at

both ends (see inset).

4. Reattach the nozzle to the turbine.

(b)

(a)

(c)

(d)

(f)

(e)

(g)

(h)

(i)

(j)

* Nozzle seal

It is important that the nozzle seal

inside the nozzle be re-installed

properly. Make sure the cup side of the

seal (the side with the groove) is facing

out towards the front of the nozzle.

Groove

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 20 21

No comments

WAGNER CONTROL SPRAY Owner's Manual Page 14