WAGNER CONTROL SPRAY Owner's Manual download pdf (Page 10)

English

Proper Spraying Technique

STOP

The room you are spraying must be

properly masked in order to prevent

overspray from covering woodwork,

oors or furnishings. Make sure you

have properly masked the room per the

instructions on the enclosed “Taping

Guide”.

If spraying with an air-assisted spray system is new

or unfamiliar to you, it is advisable to practice on a

piece of scrap wood or cardboard before beginning

on your intended workpiece and/or test with water.

Spray Poster

If you purchased a FLEXiO sprayer model 590, a

spray poster is included with your unit. The spray

poster can be adhered to a spraying surface and can

be used for practice. Follow the guidelines on the

poster.

Surface Preparation

All objects to be sprayed should be thoroughly

cleaned before spraying material on them. Areas

not to be sprayed may, in certain cases, need to be

masked or covered.

Spray Area Preparation

The spray area must be clean and free of dust in

order to avoid blowing dust onto your freshly

sprayed surface.

How to Spray Properly

STOP

It is important to keep your arm moving

whenever the gun is being triggered. If

you pause or linger in one spot too long,

too much material will be sprayed to the

surface.

STOP

Partially pulling the trigger will start

the turbine, but no material will spray

until the trigger is pulled fully. It is

recommended that the trigger rst be

pulled partially in order to start the

turbine before a spray pass is made.

• Position the spray gun perpendicular to and

six (6) or more inches from the spray surface,

depending upon the spray pattern size desired.

With reduced material ow and air power, you

can get closer to the spraying surface.

• Spray parallel to the surface with smooth passes

at a consistent speed as illustrated below.

Doing this will help avoid irregularities in the

nish (i. e. runs and sags).

6 to 12 inches

Correct

Even coat throughout

Keep stroke smooth and at an even speed

• Always apply a thin coat of material on the rst

pass and allow to dry before applying a second,

slightly heavier coat.

• When spraying larger surfaces, overlap each

spray pass by at least 50% This will ensure full

coverage.

• When spraying, always trigger the spray gun

after spray pass has begun and release trigger

before stopping the pass. Always keep the

gun pointed squarely at the spray surface and

overlap passes slightly to obtain the most

consistent and professional nish possible.

Incorrect

Do not ex wrist while spraying.

Light coat Heavy coat Light coat

Note: When you quit spraying for any length of

time, unplug the sprayer. When you restart, wipe

the nozzle with a damp cloth to remove any dried

paint.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 20 21

Comments to this Manuals

No comments

WAGNER CONTROL SPRAY Owner's Manual Page 10

Comments to this Manuals

Related products and manuals for Power fine-spray systems WAGNER CONTROL SPRAY