WAGNER CONTROL SPRAY Owner's Manual download pdf (Page 15)

English

Maintenance

Cleaning the Filters:

IMPORTANT: Before every use, you should

inspect the air lters in the turbine to see if it

is excessively dirty. If it is dirty, follow these

steps to replace it.

IMPORTANT: Never operate your unit

without the air lters. Dirt could be sucked in

and interfere with the function of the unit.

1. Unplug the spray gun. Push the snap levers (a)

on the two turbine covers and remove them.

Remove the dirty lters and replace with new

ones. The smooth side of the air lter must be

placed toward the turbine. Secure the covers

back onto the turbine.

Cleaning the Air Valve Tube (iSpray only):

Note: If paint has entered the air tube, proceed as

follows.

1. Pull the air tube (a) at the top from the nozzle. Screw

o the valve cover (b). Remove the valve seal (c). Clean

all the parts carefully.

IMPORTANT: The air tube and valve seal (c) are only

solvent-resistant to a limited extent. Do not immerse

in solvent, only wipe.

2. Place the valve seal (c) in the valve cover (b) with the

pin facing into the tube.

Note: Installing the valve seal into the valve cover will

be much easier if the valve cover is inverted.

3. Turn the nozzle upside down and screw on the valve

cover (with valve seal inside) from underneath.

Note: Turning the nozzle upside down will prevent

the valve seal from falling out of the valve cover during

reinstallation.

4. Place the air tube on the valve cover and on the nipple

at the nozzle.

(a)

(b)

(c)

(b)

(a)

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 21

No comments

WAGNER CONTROL SPRAY Owner's Manual Page 15