WAGNER PaintMate User Manual download pdf (Page 5)

English

3. Assemble the main tube and plunger.

4. Pack a small amount of petroleum jelly

thoroughly around and between the O-ring

and inside the seal.

5. Assemble the fill valve assembly.

6. Apply a thin layer of petroleum jelly to the tip

of the roller arm and bearing surfaces.

7. Place the seal on the end of the roller arm in

the proper direction.

8. Assemble the roller arm, core, sleeve, and

cover.

Assembling the Roller Arm

1. To assemble the roller arm, push the end

cap (1) firmly into the roller cover (2).

2. Slide the distribution tube (3) onto the

plastic roller core (4).

3. Slide the roller cover/end cap assembly (5)

over the plastic roller core/distribution tube

assembly (6) and turn this assembly by

hand to thread it onto the end cap.

4. While holding the protruding end of the

roller core with one hand, tighten the end

cap securely with a screwdriver (Fig. 2).

5. Slide this assembly (7) onto the roller arm

(8) until it locks into place with the locking

tab (9).

Roller Cover

Roller Core

Tighten

End Cap

Fig. 2

Roller Core

(4)

Roller Arm (8)

Locking Tab (9)

DistributionTube

(3)

Roller Cover

(2)

End Cap

(1)

(6)

(5)

(7)

Fig. 1

Petroleum Jelly

Petroleum

Jelly

NOTE: When putting the plunger back

into the main tube, make sure

the O-rings do not twist or cut.

©1998 Wagner Spray Tech. All rights reserved. 5

R

0284890G.doc 3/22/00 2:26 PM Page 5

1 2 3 4 5 6 7 8 9 10 ... 15 16

Comments to this Manuals

No comments