WAGNER PaintMate User Manual download pdf (Page 4)

English

4 ©1998 Wagner Spray Tech. All rights reserved.

Cleaning the Roller Arm Assembly

Rinsing the Roller Arm

1. Fill your bucket with warm water and soap

if you used latex paint. Fill your bucket

with mineral spirits if you used an oil-

based paint designed to be cleaned up

with mineral spirits.

2. Remove the spatter shield from the roller

assembly if it is installed.

3. Press the locking tab and let the roller

drop off the roller arm and into the bucket.

4. Unscrew the roller core from the end cap

and slide the roller cover off. Place the

roller core and cover into the bucket.

If you place a rag over the roller cover,

then grip the end of the roller core and

twist, you can cleanly and easily remove

the roller core. Once the core is free of

the cap, tap the core on a table or the

palm of your hand to knock the roller cap

loose and remove it from the cover.

5. Make certain the switch on the main tube

is set to FILL, and then submerge the end

of the roller arm in the bucket.

6. Pull the plunger back to draw cleaning

solution into the main tube and push it

forward to circulate the cleaning solution

through the tube. Do several times until

the main tube looks clean.

7. Remove the seal from the end of the roller

arm. Note the direction of the lip for

correct replacement. Clean thoroughly.

8. Rinse the roller core and cover thoroughly

in the cleaning solution and remove from

the bucket to dry.

Rinsing the Fill Valve Assembly

The fill valve assembly uses a ball and check

valve system for proper filling of the main tube.

It is very important to clean this area thoroughly

to ensure the best performance from the Paint

Mate

®

.

1. Unthread the locking collar around the fill

valve and remove the rubber seal, ball,

seat, spring, and retainer disk.

2. Rinse the items thoroughly in the cleaning

solution until all paint is removed and then

allow them to dry.

Rinsing the Fill Tube and Can lid

1. Remove the can lid and tube from the

paint container and let excess paint drain

back into the container.

2. Rinse the lid and tube in the bucket of

cleaning solution until all paint is removed

and then allow them to dry.

Storing the Paint Mate

®

1. Remove the plunger from the main tube by

turning the locking collar next to the trigger

counter-clockwise until the main tube

easily slides off the plunger.

2. Pack a generous amount of petroleum jelly

thoroughly around and between the O-

rings on the plunger.

NOTE: If you are using latex paint, parts

may be rinsed in a sink using

warm water and a mild liquid

soap.

NOTE: If you are using latex paint, parts

may be rinsed in a sink using

warm water and a mild liquid

soap.

R

0284890G.doc 3/22/00 2:26 PM Page 4

1 2 3 4 5 6 7 8 9 ... 15 16

Comments to this Manuals

No comments