English
4 © Wagner Spray Tech. - All Rights Reserved
Optional Cleanup
1. Carefully remove the trigger housing
and thread the ll adapter to the paint
tube (gure 7).
2. Dip the end of the ll adapter into a
container of warm, soapy water.
3. Pull the handle and draw water into the
paint tube. Make sure the paint tube is
at least approximately a quarter full.
4. Carefully remove the ll adapter and
reattach the trigger housing and its
components.
5. Pull the roller cover o of the roller arm
and set aside.
6. With the roller arm assembly (a) pointed
into a waste container, repeatedly pump
the trigger to ush the water through
the trigger housing and roller arm
(gure 8). Rell and repeat a minimum
of 2-3 times.
7. Unthread the roller arm nut (b) from the
trigger housing (c) and remove the roller
arm (gure 9).
8. Remove the trigger housing from the
paint tube. Clean the trigger housing,
roller arm assembly, and roller cover by
hand using warm, soapy water.
Figure 9
Figure 7
PUMP
a
Comments to this Manuals