WAGNER WallPerfect W665 Operations Instructions Page 37

  • Download
  • Add to my manuals
  • Print
  • Page
    / 90
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 36
GB
29
WallPerfect W 665 I-Spray
partially or completely invalidate the liability.
How the product is handled, including preparation of the work place and spray
paint as well as the nal result, is the sole responsibility of the operator.
Wagner excludes any liability for damage which may arise from overspray, application
errors, touch-ups, or non-compliance with the instructions provided here.
21. Correction of Malfunctions
Problem Cause Remedy
No coating material
emerges from the
nozzle
Nozzle clogged
•
Material volume setting
•
turned too far to the left (-)
No pressure build-up in
•
container
Container empty
•
Feed tube loose
•
Feed tube clogged
•
Ventilating bore (Fig.11, C)
•
clogged
Clean
Turn to the right (+)
Tighten container
Rell
Insert
Clean
Clean
Coating material
drips from the
nozzle
Coating material assembly
•
at air cap, nozzle or needle
Nozzle loose
•
Nozzle seal worn
•
Nozzle worn
•
Clean
Union nut tighten
Change
Change
Atomisation too
coarse
Material volume too large
•
Material volume adjusting
•
screw turned too far to the
right (+)
Nozzle contaminated
•
Viscosity of coating material
•
too high
Too little pressure build-up
•
in container
Air lter heavily soiled
•
Turn material volume
adjusting screw to the
left (-)
Clean
Dilute further
Tighten container
Change
Spray jet pulsates Coating material in
•
container running out
Nozzle seal worn
•
Air lter heavily soiled
•
Rell
Replace
Change
Coating material
causes "paint tears"
Too much coating material
•
applied
Viscosity of coating material
•
too low
Turn material volume
adjusting screw to the left (-)
Page view 36
1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 89 90

Comments to this Manuals

No comments