WAGNER MMI 1100 Instruction Manual download pdf (Page 5)

Mode Button:

The Mode Button changes the operation mode. If the meter has been turned Off, the mode

always defaults to Mode 1 after turning power back On.

View/Change MODES Overview:

When the meter is turned On, pressing the Mode button will cause the current mode to be displayed on

the screen.

Momentarily pressing the Mode button again will increment the operating mode selection value. The

mode increments until it reaches 7 and then wraps back to 1. Momentarily pressing the On/Off button will

select the mode that is indicated on the Mode screen.

Mode 1 = Measurement Mode

This is the primary operating mode for the meter. When the meter is in this mode, it will display

instantaneous Moisture Content (MC) readings of the lumber. The meter will always default to this mode

after power on. Toggling the On/Off button in this mode will alternate between hold mode (to “freeze”

the MC reading) and Measurement mode.

Mode 2 = Measure / Store

Measure/Store (see Figure 1) is similar to Measurement mode, except that when the On/Off button is

pressed, the reading on the display is stored into memory.

The display will then momentarily indicate the memory location into which the MC reading is being

stored, as shown in Figure 2.

After the memory location is displayed the meter will revert to Measurement mode as depicted in Figure

1, showing the instantaneous MC reading. When the maximum number of readings (50) has been stored

in memory, any new reading stored will replace the oldest reading in memory, meaning that the 50 most

recent readings are always stored. MC readings below 5.0 are stored as 5.0. Readings above 30.0 are

stored as 30.0. All readings between 5.0 and 30.0 are stored as their actual reading.

Figure 1

Figure 2

1 2 3 4 5 6 7 8 9 10 11 12 13

No comments

WAGNER MMI 1100 Instruction Manual Page 5