9
Taking Measurements Continued…
Additional meter corrections may be necessary if you are measuring Raft Wood (salt water permeated), or
lumber treated with CCA, ACQ or any other treatment with metallic or other components that might bias
the moisture readings.
4
Auto-Shutdown:
The meter will automatically shutdown in 60 seconds when the meter’s moisture content reading has not
changed by more than 2%, and none of the meter buttons have been pressed. The shutdown timer will
reset anytime the meter reading changes more than 2%, or a button has been pressed.
Low Battery Indicator:
If the meter is On, and battery voltage is low, the LO BAT indicator will be shown on the left side of the
display. When the LO BAT indicator is on, you must replace the battery or the meter may not function
properly. If the battery needs to be replaced, use either a 9-volt alkaline or a ni-cad rechargeable. Be sure
to observe proper battery polarity.
For a long service life, it is important to store your meter properly. Avoid excessively hot or cold
locations, and keep the meter in the case provided. Do not store the meter in an area with excessive
electro-magnetic interference, such as near an electric motor, or where it could be crushed, such as in
front of a forklift. Do not leave the meter in an operating kiln during the drying cycle.
The meter has been calibrated at the factory and should not require re-calibration. If you need to have the
calibration verified, please contact the Wagner Meters Sales Department to purchase a calibration
verification block if you don’t already have one. Should the meter need to have a calibration adjustment,
it will need to be returned to Wagner Meters Technical Services Department.
Footnotes:
4
Contact Wagner Meters Technical Services for further information for these applications.
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals