search

WAGNER CONTROL SPRAY Owner's Manual Page 4

  • Download
  • Add to my manuals
  • Print
  • Page
    / 10
  • Table of contents
  • TROUBLESHOOTING
    •
  • BOOKMARKS
    • Rated. / 5. Based on customer reviews
Page view 3
4
English
Setup
Material Preparation
1. Stir the spraying material thoroughly before measuring
viscosity.
2. Dip the viscosity test cup completely into the spraying
material.
3. Hold the test cup up and measure the time in seconds until
the liquid empties out. This time is referred to below as
Runout Time.
MATERIAL FLASH POINT MUST BE 70°F (21°C) OR
HIGHER.
Fill Container
1. Unscrew the cup from the spray gun.
2. After the material has been properly thinned and strained,
fill the container to the top of the neck.
3. Carefully screw the cup back onto the spray gun.
Material to be sprayed should always be strained to
remove any impurities in the paint which may enter and
clog the system. Impurities in the paint will give poor
performance and a poor finish.
Thinning Chart
Material Runout Time
1) Oil enamel
2) Oil based primer
3) Oil stain
4) Clear sealer
5) Polyurethane
6) Varnish
25-40
30-45
No thinning required
No thinning required
No thinning required
20-50
Before spraying, the material being used may need to be
thinned with the proper solvent as specified by the
material manufacturer. Never exceed the thinning
advice given by the coating manufacturer.
Do not use materials with a flashpoint below 70°F
(21°C). Follow the instructions below.
Assembly
1. Align the arrow on the spray gun with the “unlock” symbol
on the turbine.
2. Insert and twist the spray gun into the turbine toward the
“lock” symbol on the turbine. The tab below the trigger will
lock the two pieces into place.
Aligning the Suction Tube
By pointing the suction tube in the proper direction, you
will not have to refill the container as often.
If you are going to be spraying in an upward direction,
the angled end of the suction tube should be pointing
toward the rear of the gun.
If you are going to be spraying in a downward direction,
the angled end of the suction tube should be pointing
toward the front of the gun.
Page view 3
1 2 3 4 5 6 7 8 9 10

Comments to this Manuals

No comments
Related products and manuals for Power fine-spray systems WAGNER CONTROL SPRAY
Power fine-spray systems WAGNER W660 User Manual      (22 pages)
Power fine-spray systems WAGNER 4-STEP ELECTRONIC PRO DUTY POWER PAINTER Owner's Manual    (24 pages)
Power fine-spray systems WAGNER Power Painter Owner's Manual    (16 pages)
Power fine-spray systems WAGNER Paint Crew Owner's Manual    (26 pages)
Power fine-spray systems WAGNER W450 SE Operations Instructions      (48 pages)
Power fine-spray systems WAGNER W180P Service Manual   (12 pages)
Power fine-spray systems WAGNER RADIATOR SPRAY-ATTACHMENT User Manual      (24 pages)
Power fine-spray systems WAGNER W 95 Operations Instructions   (14 pages)
Power fine-spray systems WAGNER Optimus Owner's Manual    (14 pages)
Power fine-spray systems WAGNER WideShot Owner's Manual    (13 pages)
Power fine-spray systems WAGNER 0529002 Instruction Manual   (13 pages)
Power fine-spray systems WAGNER 0518050 Instruction Manual     (28 pages)
Power fine-spray systems WAGNER 0520000 Instruction Manual     (20 pages)
Power fine-spray systems WAGNER 0529029 Installation Guide    (28 pages)
Power fine-spray systems WAGNER 0529017 Use and Care Manual   (5 pages)
Power fine-spray systems WAGNER 0529010 Use and Care Manual   (6 pages)
  • SELWOOD Datakam Advansus B-K Medical SEIKI Digital
  • AEG Fridge-freezers Peavey Guitar accessories Sony MP3/MP4 player accessories Honeywell Oxygen Equipment Citizen Label printers
  • Rubbermaid FG5L3000SDONX Yamaha YT100 Sony DCR-DVD201 Electrolux EKC51350OW Philips HP6574/11
  • Alcatel 4045X User Manual Rancilio Silvia Service Manual Amana AMV2307PFB Dimensions Guide Dynex DX-LTDVD19 Specifications